Installation and Commissioning
This section will tell you what is needed to carry out a correct installation and how to go about it. Make sure you are familiar with all the safety instructions mentioned above and ensure that all protective measures are observed.
Carefully remove the device from the packaging. Check the packaging and the device for transport damage. If the device is damaged, report this immediately to your post office or shipping company with a corresponding damage report.
Please keep the packaging so that you can repack the device properly if necessary.
The charger can be installed in any position. Choose a location that is protected from unauthorized access (especially by children). This location must be dry and protected from moisture and high humidity.
Warning! The device must not be installed in an explosive environment.
Please note that there must be a minimum clearance of 2.5cm on all sides of the device to allow for the necessary cooling. If the device is installed in a box or in a location with poor ventilation, this may affect the functionality of the charger due to reduced cooling.
Electrical Connection
Connect the charger to the power supply using the power cable provided. Connect the cable to the wheelchair. The wheelchair's battery will charge.
Please check that the cable is intact before each use. If the cable is damaged, the product must not be used until the cable has been replaced.
Once the charging process is complete, the charger can be disconnected from the wheelchair and the power supply.
Modifications of any kind to the cables are not permitted.