Additional plate for stepped trunks
For stepped trunks, there is the option of an additional plate. This can be ordered in addition to the car ramp and enables the support wheels to roll down in a controlled manner into a stepped trunk.
 |
Assembly
 | Mount the hinge to the head using two M6 x 16 mm screws and two M6 lock nuts. Make sure that the hinge is oriented parallel to the head. Tighten the screws with a torque of 4.7 Nm. |  |
 | Mount the additional plate to the hinge using two M6 x 16 mm screws and two M6 lock nuts. Make sure that the straight edge of the additional plate is facing inward (as shown in the first illustration in Chapter 5) and that the hinge is straight. Tighten the screws firmly with a torque of 4.7 Nm. |  |
 | Cover the locking nuts, which are mounted on the hinge on the head side, with cover caps. |  |
Use
When using the additional plate for stepped trunks, it must be ensured that the additional plate touches the floor of the trunk (see picture).
 |